Dodge RAM 2003 high-line injectors with Injector Body Modification

$4,720.00$5,610.00

Clear
SKU: N/A Category:

Description

Body modified injectors have internal modifications to the injector to lift and close the needle faster than factory injectors. Because of this faster operation you can inject the same amount of fuel with less pulse width. Injecting the same amount of fuel in less time gives the fuel air mixture more time to combust. This makes a huge difference at high rpm. Notice the dyno plot in the picture section. Although the peak power was similar, notice the power increase of almost 200hp above 4,000rpm. Ask about our Ultra BBI upgrades for your competition upgrade for up to 3,000hp!

Originally these injectors have a flow rate of 60 l/h @ a pressure of 100bar.

Stage 1: Our Injector flow rate is 78 l/h/100bar –> 30% increase compared to stock.
For model years 2003-2004 we utilize a 143° spray angle

These injectors are capable of up to 700rwhp. Injection quantity reduction is a simple adjustment, thanks to aftermarket tuners. Decrease fuel quantity to satisfy the needs of your current set up, or crank it up to 700 RWHP with 10mm cp3.

Stage 2: Injectors have a flow rate of 103 l/h/100bar –> 72% increase compared to stock
For model years 2003-2004 we utilize a 143° spray angle

These injectors are capable of up to 1000rwhp. Dual hi-pressure cp3 injection pumps are required or a 12mm single cp3. You can also use these injectors with minimal engine modifications with de-tuning. Decrease fuel quantity to satisfy the needs of your current set up, or crank it up to 1000 RWHP.

Stage 3 Injectors have a flow rate of 120 l/h/100bar –> 100% increase compared to stock
For model years 2003-2004 we utilize a 143° spray angle

These injectors are capable of above & beyond 1000rwhp. Dual hi-pressure cp3 injection pumps or 12mm cp3 are required.

Stage 4: Injectors have a flow rate of 144 l/h/100bar –> 163% increase compared to stock
Injector output with changed setup –> 163% increase compared to stock (full load injection 1600bar/1700µs). The higher the rpm, the higher the difference in performance! A 14mm cp3 is required or dual cp3s.

Additional information

Stage

Stage 1, Stage 2, Stage 3, Stage 4

Type (Street Only)

Engine Model