Shop – admin

Out of stock

Zinc Additive

$12.99 – $160.00

With most current diesel oils this additive will put your zinc and phosphorous at approximately 1500-1650ppm which is ideal for flat tappets cams. Use every...

Select options

103# 24v springs

$325.00

Stock 24v springs have 78-82lbs of seat pressure at 1.380″. If you are over 35psi(boost or drive pressure), stock springs do not fully control the...

24 Valve Extreme Duty Pushrods 12mm

$179.00

If you are over 500hp, the cylinder pressures acting on the valve can bend your OEM pushrods before the valve opens. This can retard cam...

Bolt on Cam Retainer

$39.99

For use with mechanically injected engines with helical cut cam gears. The bolt on retainer will ensure that the cam gear is not pushed off...

1.45″ tappets

$159.00

These tappets work with all 1989-2016 Dodge Cummins engines. At 1.45″ they will not have interference with the Fuel pump eccentric on 12v engines and...

24 Valve tool steel retainers

$99.00

If you are running over 4,500 rpm and have a cam with large lobe lift, then these retainers are a must. Over 4,500 can only...

24 Valve Spring Compressor Tool

$89.00

Makes changing out your valve springs while in the engine very easy. Works with both stock springs and aftermarket valve springs.

12 Valve 165# springs

$399.00

Seat Pressure 165 lbs, comes with retainers and locks. Optional locks are available for .075″ higher installed height If you are over 30lbs of boost/drive...

12 Valve Extreme Duty Pushrods

$224.51

If you are over 500hp with your 6bt, the cylinder pressures dictate that you step up to our extreme duty pushrods which consist of a...

24 Valve efficiency 178/208 Camshaft Combo

$1,325.00

What’s included: 178/208 Camshaft (fits 89-2018 Cummins) Heavy duty pushrods (500-750 hp) 103 Valve Springs Lifters/tappets Information: RPM Range: Idle-4000 Drops EGT 200-300 Better fuel...

Bronze Cam Retainer

$89.00

Factory replacement for thrust plate retainer

In stock

Cam Bearings

$18.99 – $125.00

$18.99 Per Cam Bearing. These high performance bearings are made in the USA for Hamilton Cams. For use when replacing the OEM bearings. 12 valve...